Incredible Reset Maintenance Light Toyota Corolla 2010 Ideas
Incredible Reset Maintenance Light Toyota Corolla 2010 Ideas. A buzzer sound and the maintenance light should start to flash. On a 2010 toyota corolla, how do you turn the maintenance light back on?
How to Reset Maintenance Light Toyota Corolla 2016 from itsengine.com
A buzzer sound and the maintenance light should start to flash. Activate the off position on the ignition switch. If you would like me to do another.
Please Check Your Owner's Manual For Reset Instructions Pertaining To Your Vehicle.
Hold the trip reset button down until your odometer lights 0 miles. Press the “engine start stop” switch once (do not start engine) or turn ignition key to run (one position before starting engine). Turn your car to the “on” position (position two).
A Buzzer Sound And The Maintenance Light Should Start To Flash.
Activate the off position on the ignition switch. Ensure trip metre a reading is shown. 3.turn ignition switch to the “acc” position.
Once The Corolla Is Running, The Light Ought To Be Off.
Turn the key on, but don’t start the engine. 1.turn the ignition switch to the “on” position. Web on my 2010 corolla, i found out that you have to set the odometer to trip a, then off, hold down odometer button while turning key over to acc again to reset the maint reqd light.
Turn The Ignition To The “On” Position.
What does a 2010 toyota corolla “maintenance necessary” mean? References 2010 toyota corolla owners manual; Web 2010 toyota corolla maintenance light reset instructions.
The Maintenance Light Will Thereafter Go Out.
You can follow the steps below to turn the maintenance light off: Web this video shows u how to reset the maint req'd light after doing an oil change on a 2010 toyota corolla. While pressing the trip meter reset button, press the “engine start stop.
No comments:
Post a Comment